When the burr appears in the JIS G3455 STS370 steel pipe laser cutting workpiece, many enterprises will suspect that the laser cutting machine has quality problems. In fact, this phenomenon is mostly caused by the operator's wrong way of operation, or the maintenance of the cutting machine, maintenance is not in place. In addition, this happens with auxiliary gases.
The upper and lower position of the laser beam focus produced by laser cutting JIS G3455 STS370 steel pipe is deviated, resulting in energy not just converging on the workpiece, the workpiece is not fully vaporized, so that the slag production increases, it is not easy to blow off, and it is easier to produce burrs.
The output power of laser cutting JIS G3455 STS370 steel pipe is not enough to effectively vaporize the metal, resulting in excessive slag and burr.
The cutting line speed of JIS G3455 STS370 steel pipe laser cutting is too slow, which destroys the surface quality of cutting surface and produces burr.
JIS G3455 STS370 steel pipe laser cutting auxiliary gas purity can not meet the requirements of the standard, will also make the workpiece burr.
The working time of laser cutting JIS G3455 STS370 steel pipe is too long, so that the equipment has an unstable working state, which will also lead to the generation of burrs.
